Home > Products > Power Supplies > Programmable Single Output DC Power Supplies > Model VSP2050GPIB

0-20V, 0-50A High Power Switching Power Supply w/GPIB
Model VSP2050GPIB (The VSP2050GPIB has been discontinued.)

Discontinued Instrument Trade-in Program

The VSP2050GPIB was DISCONTINUED on January 1st, 2010 and was replaced by the XLN3640-GL.

You may upgrade your discontinued VSP2050GPIB with a new XLN3640-GL at a saving.
We even cover shipping costs to your U.S. address.

 

XLN3640-GL Retail Price: $2,495.00
Your Savings: -$623.75**
Price w/ Trade-in: $1,871.25*

* CA residents add 8.75% Sales Tax
** savings on new instrument + USD $20.00 savings on shipping cost

 

Model XLN3640-GL

View model overview

• Overview
• Documentation

The VSP Power Supply series utilizes modern switch mode technology to produce high-power, low-noise switching supplies that cost around twenty five percent less than linear supplies with the same power. The VSP series offers as much as 1.2 kilowatts in a 19 inch rack mountable chassis that measures just 1U (1.75 inches) in height. The VSP series power supplies can provide precise output voltage control via manual tuning utilizing front panel mounted ten-turn potentiometers or by remote control from an RS 232 interface (provided on standard VSP models) or by GPIB interface (add "GPIB" to the model number for a VSP with GPIB interface instead of RS 232). All models have remote sensing capabilities to automatically maintain desired voltage levels at the load.

• Provides 1.2 kilowatts at 20V, 40V, 60V and 120V output voltages (output voltages vary between different models)
• Compact 1U (1.75 in by 19 inch rack mountable chassis) is just a home on a bench as it is in a Rack
• Up to nine units can be cascaded, producing more than 10 kilowatts of DC power
• Front-to-back air flow allows full power operation without space between supplies
• Output on/off switch on front of unit
• GPIB interface included on this model instead of RS 232

• Datasheet (PDF file)
• Manual (PDF file)
• Product FAQs
• Q: How do I get the trip light to stop flashing?
  A: Turn the OVP screw up until the Over Voltage Protection is about 2-3 volts above the limit.
• Q: My unit is not communicating via GPIB.
  A: Make sure the dip switches to the right of the GPIB connector have the following settings #1, 2, 3, 4, & 6 are up (off) pins 5, 7, and 8 are down (on). Then cycle power off and then on.
• Specifications

22820 Savi Ranch Parkway - Yorba Linda, CA 92887 - (714) 921-9095 - (800) 462-9832 - Fax: (714) 921-6422 - © 2008-10 B&K Precision Corp. (Site Map)